Elastic and elastic coefficient

2018-07-23 12:12:53 SUSHI GUANGBO TEST TECHNOLOGY CO.,LTD 已读
Elastic and elastic coefficient
 
The mechanical properties of metal materials refer to the ability of the workpiece to resist deformation when subjected to external loads (tensile, compressive, bending, torsional, impact, alternating stress, etc.). The commonly used mechanical properties of materials mainly include tensile strength and yield strength. Bending strength, modulus of elasticity, hardness, impact toughness, elongation, reduction in area, fatigue limit, creep curve, and the like.
 
The strength, stiffness and plasticity of the material can be determined by tensile tests, mainly room temperature tensile and high temperature tensile tests;
 
Impact toughness refers to the ability of a workpiece to resist damage under the impact load, and is a manifestation of the mechanical properties of the material under dynamic loading;
 
When subjected to alternating stress and repeated cyclic stress, the material often breaks suddenly when the working stress is less than the yield strength. This phenomenon is called fatigue. Fatigue fracture is caused by partial permanent loss or defect of the part under cyclic stress. After a certain number of cycles, the defect expansion causes the component to suddenly fail. The test of the material fatigue limit is one of the important indicators for predicting the reliability of the part.
 
  Mechanical properties
Tensile properties (room temperature / high temperature)
tensile strength
Hardness test
Rockwell hardness
Yield Strength
Surface Rockwell hardness
Non-proportional extension strength
Brinell hardness
Young's modulus
Vickers hardness
Elongation at break
Micro Vickers hardness
rate of reduction in area
Leeb hardness
Tensile creep
Indentation hardness
Impact performance (room temperature / low temperature)
Impact toughness
Shear test
Shear strength
Low temperature brittleness
Shear resistance
Compression performance
Compressive strength
stress test
Fatigue limit
Compressive yield strength
Other mechanical tests
Torsional strength
Compression modulus
Cupping test
Flattening test
Hole expansion test
Bending test
Bending strength
Flaring test
Non-proportional bending stress
Coating adhesion
Flexural modulus
Screw guarantee load
Recommendation
Service flow

服务流程.jpg

简体中文 ENGLISH